Clear coat layer mistake

Discuss anything after that final masking comes off.



Non-Lurker
Posts: 6
Joined: Tue Jun 07, 2016 2:44 pm
Location: Kaministiquia, Ontario
Country:
Canada
PostPosted: Fri Oct 21, 2016 6:26 pm
I had my car just about finished when I thought I should add a little more clear coat, well the material ended up with in my gun was "mat" clear coat. Did about a third of the car. Do I have to sand it all down, or is there some other method to correct my mistake.

Garageaddict

User avatar

Board Moderator
Posts: 9878
Joined: Fri Oct 20, 2006 12:40 pm
Location: ARIZONA
PostPosted: Fri Oct 21, 2016 7:55 pm
If you are still in the re-coat window then apply another two or more coats of the gloss clear.

If you are out of the re-coat window you will need to scuff the clear with a Gray Scotch pad until dull or wet sand with 800 grit just until dull and then shoot more clear.
1968 Coronet R/T


ACTS 16:31



Non-Lurker
Posts: 6
Joined: Tue Jun 07, 2016 2:44 pm
Location: Kaministiquia, Ontario
Country:
Canada
PostPosted: Sun Oct 23, 2016 10:21 am
Thank you very much. I'm still in the clear coat mode. I was thinking I'd have to sand away all traces of the mat first. Glad I asked. Thanks again.

That's not the only question I have, I'll be back. Have a good, safe day.

Return to Cut, Buff, Polish & Detail

Who is online

Users browsing this forum: No registered users and 36 guests