Inconsistent with first buff
Posted: Fri Apr 27, 2018 4:34 pm
So I repainted my "total disaster" came out much better with the help of this board! I was unable to sand shortly after painting so the paint got really hard, I had to hit a few areas with 800 then flattened it with 1000 completely. I did my first buff with meguiars 105 and noticed a few spots that still look slightly "milky" as opposed to the rest that shows a decent reflection. Should I be concerned or go on to the 205, then polishing?
This is Kirker Single stage white paint.
I also found a few spots of orange peel I missed so I have to do a little bit of sanding as well. Figured I would wait to do the entire truck, get the bed back on and go over it in detail. Going to stop at this point with the 105 and figured I would do the cab with 105 then the entire truck 205 and so on.
Thanks
This is Kirker Single stage white paint.
I also found a few spots of orange peel I missed so I have to do a little bit of sanding as well. Figured I would wait to do the entire truck, get the bed back on and go over it in detail. Going to stop at this point with the 105 and figured I would do the cab with 105 then the entire truck 205 and so on.
Thanks