Here's some raw fabrication starting with a flat sheet. This duct allows better air flow through a front mounted oil cooler on my Porsche 911.
Before:
After:
Working!
Oil Cooler Duct Work Fab
3 posts
• Page 1 of 1
Top Contributor
Posts: 6233
Joined: Tue Sep 16, 2008 1:17 pm Location: Pahrump NV. Country: USA |
Looks like you welded all of it?
Was this made from Steel or Aluminum? what was your lay up? Did you bend any of it on a Break? Are you using any fans in your design? wear does the air exit? Are you planning the use of Naca ducts to pull the air through ? Dennis B.
A&P Mechanic, FCC General radio Telephone Operator Line Maintenance A&P Mechanic and MOC Tech specialist. |
Hi,
Two of the flanges were formed on a bead roller. I have a press brake but it only makes linear bends. No fans. Air exits under the car, Not sure what a naca duct is. Most of the above is explained in the video, ha ha. Why don't you like video links again? Tom |
|
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 37 guests