I just painted my camaro with single stage enamel from spray cans (duplicolor hi build), and i have really bad tiger stripes and orange peel all over. I’m just wondering what steps I should take to fix without burning through too much paint. Also would clear coating this help at all?
Any help is appreciated thanks!
Help fixing single stage enamel!
4 posts
• Page 1 of 1
Non-Lurker
Posts: 2
Joined: Mon Mar 11, 2019 4:47 pm Country: Canada |
|
You used spray can enamel on Camaro?
That stuff is basically an industrial coating Get out you sander and sand every little bit of that enamel off, then re-do it with proper automotive paints. Alternately sand back the orange peel until it's flat, then respray in a series of light coats, making sure that the can is not angled relative to the surface and you overlap each pass by about 75%. The tiger stripes come from tilting the can while the orange peel results from, usually, too heavy application. Chris
|
|
Non-Lurker
Posts: 2
Joined: Mon Mar 11, 2019 4:47 pm Country: Canada |
Don’t be too disappointed, lower your standards of camaros |
No fan of rattle can paint jobs!
I agree with strip it and paint it correctly using quality automotive paint and materials. 1968 Coronet R/T
ACTS 16:31 |
|
4 posts
• Page 1 of 1
Return to Cut, Buff, Polish & Detail
Who is online
Users browsing this forum: No registered users and 58 guests