Have a fender which have previously been sprayed with 1k primer which i leveled with 320 block to put 2k acrylic filler on top. Had a few burn troughs on high spots in the 1k showing old 2k clear and epoxy on few places. After spraying 2 medium wet coats of 2k i can see a slight ring around the burn troughs.
Which is the best way to go about here without creating unnecessary work for myself? Should i sand it all down with 180 back to the burn throughs and feather them with 180 or should i sand it all flat with finer grit and put another coat on?
Edge mapping in 2k primer
5 posts
• Page 1 of 1
Settled In
Posts: 78
Joined: Sun May 26, 2019 3:38 pm Country: Sweden |
|
usually edge mapping will go away after sanding,
you got a pic ? Experienced Trained Certified
SATA Spray Equipment Germany Axalta ChromaBase Elite Standox Imron 5000 6000 PPG Delfeet Deltron Global Matthews Sherwin Williams Ultra 7000 Genesis Valspar DeBeer LIC Akzo Nobel Sikkens Lesonal |
|
Settled In
Posts: 78
Joined: Sun May 26, 2019 3:38 pm Country: Sweden |
I get make to you with pics later today. Not sure if the camera can pick it ut. You can barley see it. After first coat of 2k it looked like a light reaction with the old surface. Second coat, barley visible.
|
then it will go away when you sand
Experienced Trained Certified
SATA Spray Equipment Germany Axalta ChromaBase Elite Standox Imron 5000 6000 PPG Delfeet Deltron Global Matthews Sherwin Williams Ultra 7000 Genesis Valspar DeBeer LIC Akzo Nobel Sikkens Lesonal |
|
Settled In
Posts: 78
Joined: Sun May 26, 2019 3:38 pm Country: Sweden |
Ok. Thanks
Its very hard to pick up on pics. I think i put the first coat on too heavy. |
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 120 guests