Edge mapping in 2k primer

General Discussion. Make yourself at home...read, ask and answer!



Settled In
Posts: 52
Joined: Sun May 26, 2019 3:38 pm

Country:
Sweden
PostPosted: Wed Jun 12, 2019 3:32 am
Have a fender which have previously been sprayed with 1k primer which i leveled with 320 block to put 2k acrylic filler on top. Had a few burn troughs on high spots in the 1k showing old 2k clear and epoxy on few places. After spraying 2 medium wet coats of 2k i can see a slight ring around the burn troughs.

Which is the best way to go about here without creating unnecessary work for myself? Should i sand it all down with 180 back to the burn throughs and feather them with 180 or should i sand it all flat with finer grit and put another coat on?

User avatar

Top Contributor
Posts: 1316
Joined: Tue Apr 26, 2016 6:53 pm
Location: Denver, CO
Country:
USA
PostPosted: Wed Jun 12, 2019 7:55 am
usually edge mapping will go away after sanding,

you got a pic ?
Experienced Trained Certified

SATA Spray Equipment Germany
Axalta ChromaBase Elite Standox Imron 5000 6000
PPG Delfeet Deltron Global Matthews
Sherwin Williams Ultra 7000 Genesis
Valspar DeBeer LIC
Akzo Nobel Sikkens Lesonal



Settled In
Posts: 52
Joined: Sun May 26, 2019 3:38 pm

Country:
Sweden
PostPosted: Wed Jun 12, 2019 8:58 am
I get make to you with pics later today. Not sure if the camera can pick it ut. You can barley see it. After first coat of 2k it looked like a light reaction with the old surface. Second coat, barley visible.

User avatar

Top Contributor
Posts: 1316
Joined: Tue Apr 26, 2016 6:53 pm
Location: Denver, CO
Country:
USA
PostPosted: Wed Jun 12, 2019 12:39 pm
then it will go away when you sand
Experienced Trained Certified

SATA Spray Equipment Germany
Axalta ChromaBase Elite Standox Imron 5000 6000
PPG Delfeet Deltron Global Matthews
Sherwin Williams Ultra 7000 Genesis
Valspar DeBeer LIC
Akzo Nobel Sikkens Lesonal



Settled In
Posts: 52
Joined: Sun May 26, 2019 3:38 pm

Country:
Sweden
PostPosted: Wed Jun 12, 2019 1:12 pm
Ok. Thanks
Its very hard to pick up on pics. I think i put the first coat on too heavy.
Attachments
20190612_200948.jpg

Return to Body and Paint

Who is online

Users browsing this forum: No registered users and 68 guests