Material Advice. Lost

Anything goes in the world of fiberglass and plastic



Non-Lurker
Posts: 6
Joined: Wed Jul 15, 2020 3:45 pm

Country:
USA
PostPosted: Wed Jul 22, 2020 2:17 pm
I do so much reading, I just get lost. I have 2 things I want to paint. First a plastic bumper on my car. I want to do it like the factory, base coat, clear coat. What do I need? Small paint chips and one spot will need a very little filler. I just want to fix the rash, scuff and shoot. What primer do I need, I want to shot urethane base and clear 2k. I also read flex agent, no flex agent, it causes yellowing, mix matched paint colors. Do I need to prime the whole panel or just the filled areas? I would like to blend the clear to the edges to the factory paint on the edges that meet the fenders.

User avatar

Top Contributor
Posts: 1821
Joined: Sun Dec 16, 2012 4:46 am
Location: Canberra
Country:
Australia
PostPosted: Thu Jul 23, 2020 5:58 am
You already asked this question, here. Did you not read the reply?
Chris

Return to Fiberglass and Plastic

Who is online

Users browsing this forum: No registered users and 6 guests