Here's the situation. I sprayed ppg acrylic enamel metalic looks great except for where i ran out of paint, reloaded, and well... lost my place on the door. (not enough lighting). Now I have this one stripe that is over my % coverage and left a darker line. The paint sagged and also dragged the metalic out of place. There are 4 coats of paint on this door. Can anyone tell me if I can wet sand this stripe out with success, or should I sand and reshoot the darn thing?
Any help appreciated.
sanding out sags on acrylic enamel metallic
3 posts
• Page 1 of 1
You can try it and see how bad it will look. But I would sand and reshoot it. When you use a one step paint with metalic in it and you have to wet sand it, the metalic starts to look funny.
|
|
thanks, Horsepower I'll give it a few more days and give it a try.
I kinda figured i'd have to reshoot it. Well thanks for your input,have a good one |
|
3 posts
• Page 1 of 1
Return to Cut, Buff, Polish & Detail
Who is online
Users browsing this forum: No registered users and 38 guests